Dipanelling machine

Low cost PCB Separator with Dry Dicer WINGCUTTER

FEATURES

In order to separate PCB with Dry Dicer system, as for the cut surface being always smooth, it can hold down distortion stress when cutting off on that to the very small.

It was developed to help improve the quality of long-term aims to reduce the trouble caused by the strain aging is likely to occur.

With our advanced tip position compensator function, a steady cutting was achieved.

We challenge making the cutting powder on PCB minimum by our original absorption method.

This has adopted the diamond wheel, also recycling the grindstone is possible!
The life time detection function is installed, of course.

CUSTOMIZE

The robot can be produced with the size of customer's requirement. ( as for L size board etc.)

Ionizer, to removal electric appliance, option.

Ionizer, to removal electric appliance, option.
It can also be attached with CCD Visual compensator function capabilities of the camera.

DESCRIPTION

Utility	Power supply	Single phase AC100V
	Frequency	50 / 60Hz
	Maximum electric power consumption	3KVA
	Air supply pressure	0.5 – 0.7MPa
	Air consumption (ANR)	300L/min
	Device size (mm)	W800 X D800 X H1,750 (Excluding protrusions)
Work size	Max. board size (mm)	W300 X D350 X H2t
Robot	Axis control method	AC full digital Servo
	Drive method	AC Servo motor + Ball screw drive
	Position detect method	17 bit Incremental encoder
	Teaching method	Direct teaching method with MDI or Jogging
	No. of Program	48
	Memory capacity	Total Program Step No. : 6000steps
		Point No. :3000points
		(Part is used with the system.)
Operating range	X-axis	350mm
	Y-axis	400mm
	Z-axis	100mm
	R-axis	270°
Spindle	Motor	DC Brushless motor
	Rated Output	350W
	Rated Torque	0.16N·m
	Max. speed	8,000rpm
Grindstone		Diamond disc